주요 콘텐츠로 건너뛰기

알림: 귀하는 선행 작업 안내서를 편집하고 계십니다. 변경된 사항들은 이 선행 작업 단계를 포함하는 안내서 18개에 영향을 미칩니다.

영어
스페인어
6 단계
Slide the pick along the edge of the display, towards the headphone jack. If there is still a considerable amount of resistance when sliding the opening pick, repeat the iOpener heating procedure and apply additional heat. Be careful not to let the opening pick slide between the fused LCD and front panel, as doing so can permanently damage the display.
  • Slide the pick along the edge of the display, towards the headphone jack.

  • If there is still a considerable amount of resistance when sliding the opening pick, repeat the iOpener heating procedure and apply additional heat.

  • Be careful not to let the opening pick slide between the fused LCD and front panel, as doing so can permanently damage the display.

  • A good rule of thumb is to never insert the opening pick more than a quarter inch (6 mm) into the iPad.

Desliza la púa a lo largo del borde de la pantalla, en sentido hacia el jack de auriculares.

Si aún hay una resistencia considerable cuando deslizas la púa de apertura, repite el proceso de calentado del iOpener y aplica calor adicional.

Ten cuidado de no deslizar la púa de apertura entre el LCD y el panel frontal, hacerlo puede dañar permanentemente la pantalla.

Una buena regla general es no insertar la púa de apertura más de un cuarto de pulgada (6 mm) dentro del iPad.

귀하의 기여는 오픈 소스 Creative Commons 인가 하에 허가되었습니다.