주요 콘텐츠로 건너뛰기
영어
이탈리아어
3 단계
Now on to the formatter. Remove 2 screws on the I/O port cover. Remove 6 screws on the formatter cover.
Formatter Assembly
  • Now on to the formatter.

  • Remove 2 screws on the I/O port cover.

  • Remove 6 screws on the formatter cover.

  • Disconnect 3 connectors to the laser assembly, the cartridge connector, and the control panel.

  • Disconnect 2 flat flexible cables to the laser assembly and the control board.

  • While the service manual says not to use a PoziDriv screwdriver, I found that using a normal Phillips screwdriver on the screws in this printer would require excess force and damage the screws, but a PoziDriv screwdriver removed the screws without causing any damage.

여기에 번역 삽입

여기에 번역 삽입

여기에 번역 삽입

여기에 번역 삽입

여기에 번역 삽입

여기에 번역 삽입

귀하의 기여는 오픈 소스 Creative Commons 인가 하에 허가되었습니다.