주요 콘텐츠로 건너뛰기

알림: 귀하는 선행 작업 안내서를 편집하고 계십니다. 변경된 사항들은 이 선행 작업 단계를 포함하는 안내서 2개에 영향을 미칩니다.

영어
프랑스어

26 단계 번역 중

26 단계
Slide a plastic card underneath the center of the logic board, pushing it in as far as it will go. Slowly swing the left edge of the logic board up, while making sure it doesn't snag against any of the disconnected cables.
  • Slide a plastic card underneath the center of the logic board, pushing it in as far as it will go.

  • Slowly swing the left edge of the logic board up, while making sure it doesn't snag against any of the disconnected cables.

  • If any portion of the logic board requires excessive force to pry up, stop prying, re-apply the iOpener, and re-perform the corresponding guide steps to fully release the adhesive.

Faites glisser une carte en plastique sous le centre de la carte mère, en la poussant le plus loin possible.

Tournez lentement le bord gauche de la carte mère vers le haut, tout en vous assurant qu'elle ne reste pas accrochée aux nappes débranchées.

S'il vous faut forcer sur une partie de la carte mère pour la soulever, arrêtez de faire levier, réappliquez l'iOpener et ré-exécutez les étapes correspondantes du tutoriel pour faire complètement céder l'adhésif.

귀하의 기여는 오픈 소스 Creative Commons 인가 하에 허가되었습니다.