주요 콘텐츠로 건너뛰기

알림: 귀하는 선행 작업 안내서를 편집하고 계십니다. 변경된 사항들은 이 선행 작업 단계를 포함하는 안내서 2개에 영향을 미칩니다.

26 단계 번역 중

26 단계
Slide a plastic card underneath the center of the logic board, pushing it in as far as it will go. Slowly swing the left edge of the logic board up, while making sure it doesn't snag against any of the disconnected cables.
  • Slide a plastic card underneath the center of the logic board, pushing it in as far as it will go.

  • Slowly swing the left edge of the logic board up, while making sure it doesn't snag against any of the disconnected cables.

  • If any portion of the logic board requires excessive force to pry up, stop prying, re-apply the iOpener, and re-perform the corresponding guide steps to fully release the adhesive.

ロジックボード中心部の下からプラスチックカードをスライドさせ、できるところまで押し続けます。

未接続のケーブルに当たらないように確認しながら、ロジックボードの左端をゆっくりと振り上げます。

ロジックボードのいずれかの部分を持ち上げるのに、かなりの力が必要な場合は作業を中断して、iOpenerで温めなおします。完全に接着剤を剥がすためのガイド手順を繰り返してください。

귀하의 기여는 오픈 소스 Creative Commons 인가 하에 허가되었습니다.