주요 콘텐츠로 건너뛰기

알림: 귀하는 선행 작업 안내서를 편집하고 계십니다. 변경된 사항들은 이 선행 작업 단계를 포함하는 안내서 2개에 영향을 미칩니다.

5 단계
Push with your fingers on the rear panel behind the putty knife to minimize bending. Slowly flex the putty knife, as shown in the picture, to ensure that most of the metal tabs on this side of the iPod are disengaged.
  • Push with your fingers on the rear panel behind the putty knife to minimize bending. Slowly flex the putty knife, as shown in the picture, to ensure that most of the metal tabs on this side of the iPod are disengaged.

  • The theory behind this method is, rather than attempting to not bend the rear panel at all, to bend it in a favorable manner that allows you to easily restore it later. Therefore, any bend in the sides of the rear panel should be drawing the lip of the rear panel away from the iPod, rather than pushing out on the curved surface. This method also disengages as many of the side clips as possible.

Drücke mit deinen Fingern unterhalb des Spachtels gegen das hintere Gehäuse, um zu vermeiden, dass es sich allzu sehr verformt. Biege den Spachtel langsam, um so den Großteil der Metallhäkchen auf dieser Seite des iPods zu trennen.

Die Theorie hinter dieser Methode: Anstatt eine Verformung des hinteren Gehäuses ganz zu vermeiden, soll die Biegung auf ein Mindestmaß beschränkt werden, was erlaubt, es später wieder zurecht zu biegen. Deshalb sollte jede Verformung den Rand weiter vom hinteren Gehäuse wegbewegen. Mit dieser Methode können viele der Clips entfernt werden.

귀하의 기여는 오픈 소스 Creative Commons 인가 하에 허가되었습니다.