메인 콘텐츠로 스킵하기

알림: 귀하는 선행 작업 안내서를 편집하고 계십니다. 변경된 사항들은 이 선행 작업 단계를 사용하는 모든 14 안내서에 영향을 미칩니다.

영어
프랑스어

11 단계 번역 중

11 단계
Remove the following 8 screws:
  • Remove the following 8 screws:

  • Five 2.3 mm Phillips #00 screws with partial threads securing the logic board to the rear case.

  • Two 2.3 mm Phillips #00 screws with full threads securing the logic board and camera.

  • One 2.9 mm Phillips #00 screw from beneath the "Do not remove" sticker.

  • Note for re-assembly:

  • The screw that goes next to the camera (bottom right orange highlighted screw) also has a metal strip that holds the camera in place.

  • Remember to put this strip back in place before you insert the 2.3 mm Phillips #00 screw with full thread next to the camera

Retirez les 8 vis suivantes:

Cinq vis cruciformes #00 de 2,3 mm à filetage partiel, qui attachent la carte mère au boîtier arrière.

Deux vis cruciformes #00 de 2,3 mm à filetage total, qui maintiennent la carte mère et la caméra.

Une vis cruciforme #00 de 2,9 mm sous le sticker "Do not remove".

Remarque pour le remontage:

La vis qui est placée près de la camera (en bas à droite en orange) dispose aussi d'une bande métallique qui maintient la caméra en place.

N'oubliez pas de remettre cette bande avant de réinsérer la vis cruciforme #00 de 2,3 mm à filetage total près de la caméra.

[* black] Remove the following 8 screws:
[* red] Five 2.3 mm Phillips #00 screws with partial threads securing the logic board to the rear case.
[* orange] Two 2.3 mm Phillips #00 screws with full threads securing the logic board and camera.
[* yellow] One 2.9 mm Phillips #00 screw from beneath the "Do not remove" sticker.
[* black] Note for re-assembly:
[* black] The screw that goes next to the camera (bottom right orange highlighted screw) also has a metal strip that holds the camera in place.
[* icon_reminder] Remember to put this strip back in place before you insert the 2.3 mm Phillips #00 screwsscrew with full thread next to the camera
[* icon_reminder] Remember to put this strip back in place before you insert the 2.3 mm Phillips #00 screwsscrew with full thread next to the camera

귀하의 기여는 오픈 소스 Creative Commons 인가 하에 허가되었습니다.