주요 콘텐츠로 건너뛰기

10 단계 번역 중

10 단계
Depending on the nature of the liquid damage, removing this shield may not be necessary, and doing so risks damaging the small components mounted on the logic board. If you decide to remove the shield, proceed cautiously and use a plastic tool such as a spudger, or a plastic opening tool to lever off the shield. Look for the dimpled tabs on the shield that reach down over the tabs attached to the mother board.
Removing the logic board shield cover
  • Depending on the nature of the liquid damage, removing this shield may not be necessary, and doing so risks damaging the small components mounted on the logic board. If you decide to remove the shield, proceed cautiously and use a plastic tool such as a spudger, or a plastic opening tool to lever off the shield.

  • Look for the dimpled tabs on the shield that reach down over the tabs attached to the mother board.

  • Using your plastic tool, catch the edge of a dimpled tab near a corner of the shield, and pry it up away from the logic board.

  • Being careful of all the tiny surface mounted components, work your way around the available edges until the shield comes free.

ダメージの状態によりますが、このシールドを取り外す必要はないかもしれません。外してしまうと、ロジックボードに取められた小さいコンポーネントにダメージを与えてしまう危険性があります。もしシールドを取り外す場合は、注意しながら作業を進め、スパッジャーやプラスチック製の開封ツールなどを使ってシールドを剥がしていきましょう。

マザーボードに留められたタブを覆っているシールド上の凹んだタブを確認してください。

プラスチック製ツールを使って、シールド隅近くの凹んだタブの端をロジックボードから外します。

シールドが外れるまで、小さい表面上に留められたコンポーネントに注意してください。

귀하의 기여는 오픈 소스 Creative Commons 인가 하에 허가되었습니다.