기기를 수리하세요

수리할 권리

상점

알림: 귀하는 선행 작업 안내서를 편집하고 계십니다. 변경된 사항들은 이 선행 작업 단계를 포함하는 안내서 5개에 영향을 미칩니다.

안내서로 돌아가기
영어
독일어
5 단계
If you are installing a replacement trackpad that didn't come with the attached flex cable, you'll need to use the cable from your old trackpad.

  • If you are installing a replacement trackpad that didn't come with the attached flex cable, you'll need to use the cable from your old trackpad.

  • To remove the flex cable from the old trackpad, first flip open the latch on the ZIF connector, opposite the cable. Then, apply a little heat from a hair dryer or iOpener to soften the adhesive securing the cable to the trackpad, and carefully peel off and remove the cable.

  • When installing your new trackpad, routing the cable through the upper case and past the logic board may be difficult. It is helpful to use the tip of a spudger to guide the connector past the logic board while pushing the cable through its slot in the upper case with your other hand.

Wenn dein Ersatztrackpad ohne das Verbindungskabel geliefert wird, musst du das Kabel deines alten Trackpads nehmen.

Um das Kabel vom alten Trackpad zu lösen, öffne erst den Verschluss des ZIF Verbinders. Dann erhitze das Kabel mit einem Fön oder einem iOpener, um den Kleber zu lösen und entferne dann vorsichtig das Kabel.

Beim Installieren deines neuen Trackpads musst du das Kabel durch das obere Gehäuse führen, was nicht ganz leicht ist. Es hilft, die Spitze eines Spudgers zu nehmen und damit den Anschluss auszurichten, während du mit der anderen Hand das Kabel durch das Loch führst.

귀하의 기여는 오픈 소스 Creative Commons 인가 하에 허가되었습니다.