Tips on How to micro Solder on a budget

영어

한국어

5 단계 번역중

5 단계

Trim to fit

Using a fine tip on my iron , I again used a 700 degree tip , dabbed the area with liquid flux and soldered the wire to the lead and exposed trace.
When done I removed tape, cleaned flux off and trimmed wire to length.
You must have a steady grip on your iron to attach the wire. By using a long wire, you make it easier to keep it in place as you solder and it's so thin you can remove the excess wire with little stress to the repair.

귀하의 기여는 오픈 소스 Createive Commons 라이선스 하에 허가되었습니다.