주요 콘텐츠로 건너뛰기

알림: 귀하는 선행 작업 안내서를 편집하고 계십니다. 변경된 사항들은 이 선행 작업 단계를 포함하는 안내서 2개에 영향을 미칩니다.

28 단계 번역 중

28 단계
As you complete the next few steps, prying adhesive securing the logic board in place, always start by testing gently to see if the adhesive is softened. If not, reheat the iOpener and reapply it to the back of the rear case. Carefully insert an opening pick under the logic board, between the front-facing camera and the battery. Be sure to insert the pick over the the antenna cable that runs along the length of the battery.
  • As you complete the next few steps, prying adhesive securing the logic board in place, always start by testing gently to see if the adhesive is softened. If not, reheat the iOpener and reapply it to the back of the rear case.

  • Carefully insert an opening pick under the logic board, between the front-facing camera and the battery.

  • Be sure to insert the pick over the the antenna cable that runs along the length of the battery.

  • Slide the guitar pick toward the front-facing camera connector, and stop at the bend in the logic board.

In den nächsten Schritten wirst du den Kleber lösen, mit dem das Logic Board befestigt ist. Heble am Anfang immer ganz vorsichtig und prüfe, ob der Kleber schon weich ist. Wenn dass nicht der Fall ist, dann erwärme den iOpener erneut und lege ihn auf die Rückseite des Rückgehäuses auf.

Setze ganz behutsam ein Plektrum zwischen Frontkamera und Akku unter das Logic Board ein.

Achte darauf, dass sich das Plektrum über dem Antennenkabel befindet. Es verläuft auf ganzer Länge über dem Akku entlang.

Schiebe das Plektrum zum Stecker der Frontkamera hin. Halte an der Biegung des Logic Boards an.

귀하의 기여는 오픈 소스 Creative Commons 인가 하에 허가되었습니다.