주요 콘텐츠로 건너뛰기

알림: 귀하는 선행 작업 안내서를 편집하고 계십니다. 변경된 사항들은 이 선행 작업 단계를 포함하는 안내서 2개에 영향을 미칩니다.

영어
프랑스어

28 단계 번역 중

28 단계
As you complete the next few steps, prying adhesive securing the logic board in place, always start by testing gently to see if the adhesive is softened. If not, reheat the iOpener and reapply it to the back of the rear case. Carefully insert an opening pick under the logic board, between the front-facing camera and the battery. Be sure to insert the pick over the the antenna cable that runs along the length of the battery.
  • As you complete the next few steps, prying adhesive securing the logic board in place, always start by testing gently to see if the adhesive is softened. If not, reheat the iOpener and reapply it to the back of the rear case.

  • Carefully insert an opening pick under the logic board, between the front-facing camera and the battery.

  • Be sure to insert the pick over the the antenna cable that runs along the length of the battery.

  • Slide the guitar pick toward the front-facing camera connector, and stop at the bend in the logic board.

Au fur et à mesure que vous avez terminé les prochaines étapes, vous décollerez l'adhésif fixant la carte mère. Commencez toujours par tester délicatement si l'adhésif a suffisamment ramolli. Sinon, réchauffez l'iOpener et reposez-le sur la coque arrière.

Insérez délicatement un médiator sous la carte mère, entre la caméra frontale et la batterie.

Assurez-vous d'insérer le médiator au-dessus du câble d'antenne, qui parcourt la batterie sur toute sa longueur.

Faites glisser le mediator vers le connecteur de la caméra frontale et arrêtez au coude formé pas la carte mère.

귀하의 기여는 오픈 소스 Creative Commons 인가 하에 허가되었습니다.