주요 콘텐츠로 건너뛰기

알림: 귀하는 선행 작업 안내서를 편집하고 계십니다. 변경된 사항들은 이 선행 작업 단계를 포함하는 안내서 2개에 영향을 미칩니다.

28 단계 번역 중

28 단계
As you complete the next few steps, prying adhesive securing the logic board in place, always start by testing gently to see if the adhesive is softened. If not, reheat the iOpener and reapply it to the back of the rear case. Carefully insert an opening pick under the logic board, between the front-facing camera and the battery. Be sure to insert the pick over the the antenna cable that runs along the length of the battery.
  • As you complete the next few steps, prying adhesive securing the logic board in place, always start by testing gently to see if the adhesive is softened. If not, reheat the iOpener and reapply it to the back of the rear case.

  • Carefully insert an opening pick under the logic board, between the front-facing camera and the battery.

  • Be sure to insert the pick over the the antenna cable that runs along the length of the battery.

  • Slide the guitar pick toward the front-facing camera connector, and stop at the bend in the logic board.

ロジックボードに留められている接着剤を剥がしていく作業で、まず最初に接着剤が柔らかくなっているか丁寧に確認作業を行ってください。もし柔らかくない場合は、 iOpener を再度温めて、背面ケースの裏側に当てます。

丁寧に開封ピックをロジックボードの下、正面カメラとバッテリーの間に差し込みます。

ピックをアンテナケーブルの上側に差し込んでいるか確認してください。これはバッテリーに繋がれています。

ピックを正面カメラコネクター側にスライドさせて、ロジックボードの角まできたら止めます。

귀하의 기여는 오픈 소스 Creative Commons 인가 하에 허가되었습니다.