주요 콘텐츠로 건너뛰기

알림: 귀하는 선행 작업 안내서를 편집하고 계십니다. 변경된 사항들은 이 선행 작업 단계를 사용하는 안내서에 영향을 미칩니다.

9 단계
Use a T6 Torx screwdriver to install two of the set screws on the side of the hard drive closest to the end of the hard drive cable that attaches to the logic board. Tighten the screws until they contact the end of the threaded holes in the side of the hard drive. They are shown correctly installed in the third picture. Tighten the screws until they contact the end of the threaded holes in the side of the hard drive. They are shown correctly installed in the third picture.
  • Use a T6 Torx screwdriver to install two of the set screws on the side of the hard drive closest to the end of the hard drive cable that attaches to the logic board.

  • Tighten the screws until they contact the end of the threaded holes in the side of the hard drive. They are shown correctly installed in the third picture.

Benutze eine T6 Torx Schraubendreher, um zwei der Stellschrauben auf der Seite der Festplatte anzubringen, und zwar an der Seite, die dem Ende des Festplattenkabels dass am Logic Board befestigt ist am nächsten.

Ziehe die Schrauben an, bis sie am Ende der Gewinde sind. Auf dem dritten Bild siehts du, wie sie richtig sitzen.

귀하의 기여는 오픈 소스 Creative Commons 인가 하에 허가되었습니다.