주요 콘텐츠로 건너뛰기

알림: 귀하는 지금 열람하신 선행 작업 안내서를 편집하고 계십니다. 변경된 사항들은 이 선행 작업 단계를 사용하는 모든 43 안내서에 영향을 미칩니다.

영어
스페인어

7 단계 번역 중

7 단계
Disconnect the trackpad and keyboard ribbon cable from the logic board, removing tape as necessary. Note: It is possible to replace the hard drive without disconnecting the keyboard from the chassis, but it will need to be held upright to keep it out of the way, while still allowing you both hands to work on the drive removal.
  • Disconnect the trackpad and keyboard ribbon cable from the logic board, removing tape as necessary.

  • Note: It is possible to replace the hard drive without disconnecting the keyboard from the chassis, but it will need to be held upright to keep it out of the way, while still allowing you both hands to work on the drive removal.

  • Be careful when removing the keyboard-trackpad ribbon cable to ensure that the rear of the upper case is disengaged from the area near the hinge. It is easy to accidentally bend the screw receivers on either side of the keyboard.

  • Remove the upper case.

Desconecta el el cable plano del trackpad y del teclado de la placa lógica, retirando la cinta según sea necesario.

Nota: Es posible reemplazar el disco duro sin desconectar el teclado del chasis, pero deberá mantenerse en posición vertical para mantenerlo alejado, al mismo tiempo que permite a ambas manos trabajar en la extracción de la unidad.

Ten cuidado al retirar el cable plano del teclado-trackpad para asegurarse de que la parte posterior de la carcasa superior esté desenganchada del área cerca de la bisagra. Es fácil doblar accidentalmente los receptores de tornillo a cada lado del teclado.

Retira la carcasa superior.

귀하의 기여는 오픈 소스 Creative Commons 인가 하에 허가되었습니다.