#1단계부터 Microtek ScanMaker 5900 New Ribbon Cable Replacement단계까지 번역하여 주십시오 - iFixit

안내서로 돌아가기

영어

이탈리아어

1 단계 번역 중

1 단계

Lift up the central plastic housing inside the scanner.

There are four plastic tabs located on the outer plastic housing. Push on each of these and pull to remove it.

Underneath you will see that the ribbon cable is attached to the circuit board.

Remove outer plastic housing

Lift up the central plastic housing inside the scanner.
There are four plastic tabs located on the outer plastic housing. Push on each of these and pull to remove it.
Underneath you will see that the ribbon cable is attached to the circuit board.

귀하의 기여는 오픈 소스 Creative Commons 인가 하에 허가되었습니다.