주요 콘텐츠로 건너뛰기

알림: 귀하는 선행 작업 안내서를 편집하고 계십니다. 변경된 사항들은 이 선행 작업 단계를 사용하는 안내서에 영향을 미칩니다.

2 단계
Starting with the battery cell closest to the dock connector, run a plastic opening tool underneath the edge of the battery closest to the logic board void to make enough room to insert the flat end of a spudger Run the flat end of a spudger along the two long sides of each battery cell to completely separate them from the adhesive securing them to the rear case.
  • Starting with the battery cell closest to the dock connector, run a plastic opening tool underneath the edge of the battery closest to the logic board void to make enough room to insert the flat end of a spudger

  • Run the flat end of a spudger along the two long sides of each battery cell to completely separate them from the adhesive securing them to the rear case.

  • If the adhesive is very difficult to separate, reheat the rear panel and try again.

プラスチックの開口ツールをドックコネクタに最も近いバッテリーセルに差し込み、ロジックボードの隙間に最も近いバッテリー端の下までスライドします。スパッジャーの平面側先端を差し込めるほどの十分なスペースを作ってください。

スパッジャーの平面側先端を各バッテリーセルの2つの長辺側に沿ってスライドし、リアケースに固定している接着剤から完全に乖離します。

接着剤を剥がすことが非常に困難な場合は、背面パネルを再度加熱してから再試行してください。

귀하의 기여는 오픈 소스 Creative Commons 인가 하에 허가되었습니다.