메뉴

설정

알림: 귀하는 선행 작업 안내서를 편집하고 계십니다. 변경된 사항들은 이 선행 작업 단계를 포함하는 안내서 14개에 영향을 미칩니다.

안내서로 돌아가기
영어
중국어
7 단계
Remove the following screws securing the logic board to the case:

  • Remove the following screws securing the logic board to the case:

  • One 2.5 mm Phillips screw near the vibrator motor

  • One 2.4 mm Phillips screw

  • One 3.6 mm standoff along the side of the logic board nearest the battery opening.

  • Use a standoff driver bit and driver handle to remove the single 3.6 mm standoff screw.

  • In a pinch, a small flathead screwdriver will do the job—but use extra caution to ensure it doesn't slip and damage surrounding components.

卸下下列将逻辑板与后壳固定的螺丝。

一个位于振动模块的2.5 mm Phillips 螺丝

一个 2.4 mm Phillips螺丝

一个3.6 mm螺丝在逻辑板右侧最接近电池开口位置。

使用专用螺丝刀或者小型平头起子来卸下单个的3.6mm隔离柱。

[* black] Remove the following screws securing the logic board to the case:
[* red] One 2.5 mm Phillips screw near the vibrator motor
[* orange] One 2.4 mm Phillips screw
[* yellow] One 3.6 mm standoff along the side of the logic board nearest the battery opening.
[* icon_note] Use a [product|IF145-343|standoff driver bit|new_window=true] or a small flathead screwdriver toand [product|IF145-326|driver handle|new_window=true] to remove the single 3.6 mm standoff screw.
[* icon_caution] In a pinch, a small flathead screwdriver will do the job—but use extra caution to ensure it doesn't slip and damage surrounding components.
[* icon_note] Use a [product|IF145-343|standoff driver bit|new_window=true] or a small flathead screwdriver toand [product|IF145-326|driver handle|new_window=true] to remove the single 3.6 mm standoff screw.
[* icon_caution] In a pinch, a small flathead screwdriver will do the job—but use extra caution to ensure it doesn't slip and damage surrounding components.

귀하의 기여는 오픈 소스 Creative Commons 인가 하에 허가되었습니다.