주요 콘텐츠로 건너뛰기

알림: 귀하는 선행 작업 안내서를 편집하고 계십니다. 변경된 사항들은 이 선행 작업 단계를 포함하는 안내서 6개에 영향을 미칩니다.

1 단계 번역 중

1 단계
Use a spudger to pry the fan connector straight up off the logic board. It is useful to twist the spudger axially from beneath the fan cable wires to release the connector. The fan socket and the fan connector can be seen in the second and third pictures. Be careful not to break the plastic fan socket off the logic board as you use your spudger to lift the fan connector straight up and out of its socket. The layout of the logic board shown in the second picture may look slightly different than your machine but the fan socket is the same.
  • Use a spudger to pry the fan connector straight up off the logic board.

  • It is useful to twist the spudger axially from beneath the fan cable wires to release the connector.

  • The fan socket and the fan connector can be seen in the second and third pictures. Be careful not to break the plastic fan socket off the logic board as you use your spudger to lift the fan connector straight up and out of its socket. The layout of the logic board shown in the second picture may look slightly different than your machine but the fan socket is the same.

Benutze einen Spudger, um den Anschluss des Lüfterkabels vom Logic Board zu trennen.

Es ist hilfreich, den Spatel axial unterhalb des Kabels zu drehen, um den Anschluss zu lösen.

Die Buchse und der Anschluss des Lüfters werden im zweiten und dritten Bild gezeigt. Sei vorsichtig, dass du die Buchse des Lüfters, die aus Plastik ist, nicht abbrichst, wenn du einen Spudger einsetzt, um den Anschluss aus der Buchse zu ziehen.

Das Layout des Mainboards im zweiten Bild sieht möglicherweise etwas anders aus als bei deinem Gerät, die Buchse des Lüfters ist aber die gleiche.

귀하의 기여는 오픈 소스 Creative Commons 인가 하에 허가되었습니다.