주요 콘텐츠로 건너뛰기

기기를 수리하세요

수리할 권리

상점

독일어
영어

Renew Kärcher K3.68 MD E-Kasten

안내서 정보

= 완료 = 미완료

      작업중인 해당 device의 특정 부분 또는 부품을 설명하여 주십시오. 예: 배터리

      제목을 작성합니다.

      이 간략한 요약은 검색 결과에서만 볼 수 있습니다.

      독자가 안내서를 파고들기 전에 배경 정보를 알려주십시오.

      안내서 단계

      1 단계 — Remove handle element

      First, the detergent dispenser must be removed, to the hose at the marked position must be removed, turn the container by slightly be removed. Remove the handle Assembly to the markedcross-head screws must be unscrewed, then the handle element can be pulled off to the front.

      2 단계 — Remove bumper

      Remove the four marked Torx TX16 screws, then remove the screws from the small side cover. The small lid can be removed then sideways. He is fitted on one side, this is done the bumper can be removed.

      3 단계 — Remove yellow Front Cap

      To disassemble the yellow front hood 6 cross head screws must be removed on the back. Also at the bottom, in the middle and on top. To reach the middle screws a 110 mm long screwdriver is necessarry. Turn the device and the yellow lid can be removed .

      4 단계 — Remove the motor unit

      Unsrew the Screws of the motor holder flange and remove the flange, then the strain relief of the cable from the mounting brackets side out, so that the engine is now freely be removed

      5 단계 — Remove the water connectors

      Remove the securing clips to remove the suction connection and the connection of the pressure side, then the ports can be situated. The inlet side goes out somewhat hard, there must be a little.

      6 단계 — Building a holder for GeradSschubführung

      This step is important because, if the top metal bracket is removed without backup, the whole pressure springs of the thrust management come out and it will be very difficult to get them back together. I've taken long two screw clamps holding together the lower straight thrust Guide

      7 단계 — Remove the control box

      Loos the four 6 mm Allen bolts and remove the metal lid, then the head carefully remove because among them are also feathers. If necessary also the seal (90814220) can be changed in this context

      8 단계 — Refer to E box

      The E-box can now be pulled off upwards. The protective earth conductor must be unscrewed from the housing. You can disassemble the E box also by pushing on the clip mounts and the hood then away, how to get on the inside. The E-box comes just completely, so that it can then be replaced

      귀하의 기여는 오픈 소스 Creative Commons 인가 하에 허가되었습니다.