주요 콘텐츠로 건너뛰기
독일어
영어

Golf 6 TDI brake pads front and rear Replacement

안내서 정보

= 완료 = 미완료

      작업중인 해당 device의 특정 부분 또는 부품을 설명하여 주십시오. 예: 배터리

      제목을 작성합니다.

      해당 1-2 짧은 문장이 검색 결과에 나타납니다.

      독자가 안내서를 파고들기 전에 배경 정보를 알려주십시오.

      안내서 단계

      1 단계 — Brake front preparation

      The car must be jacked up with a jack. Then dismantle the wheel in its engaged state. Push back the brake piston with a screwdriver. Remove the two plastic caps on the brake caliper retaining screws

      2 단계 — Brakes front brake caliper

      Remove circlip with a screwdriver. Loosen screws with a 7mm Allen key. Then the caliper can be removed by pulling it backwards. If the brake pad has a wear sensor, it must first be removed. Here with a screwdriver behind the lock release.

      3 단계 — Brakes front pads

      Hang the removed caliper with a strap, because of the brake hose can be bent. Remove the old brake lining on the piston, this is clipped. Pull off the second brake pad laterally. Then clean the brake with a steel brush.

      4 단계 — Brakes in front new pads

      Click in the new brake pad in the brake piston. With a screw clamp back the whole Bremskoben so that he goes over the pads later. Apply the second brake pad. The running surfaces of the brake pads should be slightly greased.

      5 단계 — Brakes front assembly

      When the pads are in place, replace the brake caliper and tighten. Replace the protective caps. Then check the seat.

      6 단계 — Brakes behind

      Jack up the rear of the car and remove the rear wheel. Release brake caliper screws. Unhook the parking brake cable and remove completely to the rear.

      7 단계

      Completely unscrew the brake caliper screws with a 15 mm open-end wrench. Remove brake caliper and remove old brake pads. Then clean the brakes and install new brake pads. Lubricate the treads a little.

      8 단계

      So now comes the hardest part. Normally you need a special tool for turning back the brake piston, but I have come up with a solution for myself. While pressing with my special device on the piston with the W-forceps, the piston must be screwed to the right.

      9 단계 — Required tool

      Here is my needed tool.

      귀하의 기여는 오픈 소스 Creative Commons 인가 하에 허가되었습니다.