주요 콘텐츠로 건너뛰기

알림: 귀하는 선행 작업 안내서를 편집하고 계십니다. 변경된 사항들은 이 선행 작업 단계를 포함하는 안내서 12개에 영향을 미칩니다.

8 단계
Be very careful not to touch the capacitor leads or any exposed solder joints on the back of the power supply. Only handle the board by the edges. Do not let any of the exposed solder joints come in contact with a metal surface, as that can cause a short. Flip the power supply over to access the DC power cable connection behind the logic board.
  • Be very careful not to touch the capacitor leads or any exposed solder joints on the back of the power supply. Only handle the board by the edges.

  • Do not let any of the exposed solder joints come in contact with a metal surface, as that can cause a short.

  • Flip the power supply over to access the DC power cable connection behind the logic board.

  • To disconnect the cable, squeeze the release clip on the back side of the connector, behind the logic board, and pull the connector straight out.

Sei sehr vorsichtig und berühre nicht die Anschlüsse der Kondensatoren oder offene Lötstellen auf der Rückseite des Netzteils. Fasse die Platine nur an den Kanten an.

Lasse keine der offenen Lötstellen mit einer Metallfläche in Berührung kommen, das könnte einen Kurzschluss verursachen.

Drehe das Netzteil herum, um an den Gleichstromanschluss hinter dem Logic Board zu gelangen.

Um das Kabel abzutrennen, musst du die Verriegelung auf der Rückseite des Steckers, hinter dem Logic Board, drücken, dann kannst du den Stecker gerade herausziehen.

귀하의 기여는 오픈 소스 Creative Commons 인가 하에 허가되었습니다.