주요 콘텐츠로 건너뛰기

알림: 귀하는 선행 작업 안내서를 편집하고 계십니다. 변경된 사항들은 이 선행 작업 단계를 포함하는 안내서 12개에 영향을 미칩니다.

8 단계
Be very careful not to touch the capacitor leads or any exposed solder joints on the back of the power supply. Only handle the board by the edges. Do not let any of the exposed solder joints come in contact with a metal surface, as that can cause a short. Flip the power supply over to access the DC power cable connection behind the logic board.
  • Be very careful not to touch the capacitor leads or any exposed solder joints on the back of the power supply. Only handle the board by the edges.

  • Do not let any of the exposed solder joints come in contact with a metal surface, as that can cause a short.

  • Flip the power supply over to access the DC power cable connection behind the logic board.

  • To disconnect the cable, squeeze the release clip on the back side of the connector, behind the logic board, and pull the connector straight out.

コンデンサのリード線や電源装置の背面にあるはんだ接合部の露出面に触れないように、くれぐれもご注意ください。 ボードの端のみを扱ってください。

露出したはんだ接合部がメタル表面に接触しないようにしてください。接触してしまうと、ショートしてしまう可能性があります。

電源を裏返して、ロジックボードの背後にあるDC電源ケーブル接続にアクセスします。

ケーブルの接続を外すには、ロジックボードの裏側にあるコネクタの裏側のリリースクリップを摘んで、コネクタをまっすぐ引き出します。

귀하의 기여는 오픈 소스 Creative Commons 인가 하에 허가되었습니다.