주요 콘텐츠로 건너뛰기

기기를 수리하세요

수리할 권리

상점

알림: 귀하는 선행 작업 안내서를 편집하고 계십니다. 변경된 사항들은 이 선행 작업 단계를 포함하는 안내서 5개에 영향을 미칩니다.

영어
프랑스어

11 단계 번역 중

11 단계
With the heat gun set to low, heat the bottom edge of the display to soften the adhesive holding the glass in place. A number of cables and the AirPort card lie underneath the clutch cover, so do not heat the area for too long. Slowly lift the top edge of the glass panel and gently rotate it out of the display.
  • With the heat gun set to low, heat the bottom edge of the display to soften the adhesive holding the glass in place.

  • A number of cables and the AirPort card lie underneath the clutch cover, so do not heat the area for too long.

  • Slowly lift the top edge of the glass panel and gently rotate it out of the display.

  • If necessary, use a plastic opening tool to free any part of the lower edge of the glass that is still attached.

  • Before reassembling, be sure to clean both the inside of the glass display panel and the LCD as any dust or fingerprints trapped inside will be annoyingly visible when the machine is on.

Le pistolet à air chaud réglé sur température basse, faites chauffer le bord inférieur de l'écran pour ramollir la colle qui maintient la vitre en place.

Un certain nombre de câbles et la carte AirPort se trouvent sous le cache charnière, ne chauffez donc pas trop longtemps cette zone.

Soulevez lentement le bord supérieur de la vitre et faites-la pivoter délicatement pour l'éloigner de l'écran.

Si nécessaire, utilisez un outil en plastique pour dégager toute partie du bord inférieur de la vitre, toujours attachée.

Avant le remontage, veillez à nettoyer l'intérieur de la vitre ainsi que l'écran LCD, car toute poussière ou empreinte digitale à l'intérieur se verra et gênera dès que l'ordinateur sera allumé.

귀하의 기여는 오픈 소스 Creative Commons 인가 하에 허가되었습니다.