주요 콘텐츠로 건너뛰기

알림: 귀하는 선행 작업 안내서를 편집하고 계십니다. 변경된 사항들은 이 선행 작업 단계를 포함하는 안내서 13개에 영향을 미칩니다.

영어
프랑스어
2 단계
Be very careful not to touch the capacitor leads or any exposed solder joints on the back of the power supply (boxed in red). Grasp the small tab at the end of one of the bottom edge display adhesive strips and pull the adhesive toward the top of the iMac to remove it. Repeat this step with the other adhesive strip and remove it.
  • Be very careful not to touch the capacitor leads or any exposed solder joints on the back of the power supply (boxed in red).

  • Grasp the small tab at the end of one of the bottom edge display adhesive strips and pull the adhesive toward the top of the iMac to remove it.

  • Repeat this step with the other adhesive strip and remove it.

  • If either adhesive strip breaks before it's removed, use a plastic card to slice through the remaining adhesive.

Faites très attention à ne pas toucher les fils du condensateur ou les joints de soudure exposés à l'arrière de l'alimentation (encadré en rouge).

Saisissez la petite languette à l'extrémité de l'une des bandes adhésives du bord inférieur de l'écran et tirez l'adhésif vers le haut de l'iMac pour le retirer.

Répétez cette étape avec l'autre bande adhésive et retirez-la.

Si l'une des bandes adhésives se brise avant d'être retirée, utilisez une carte en plastique pour couper l'adhésif restant.

귀하의 기여는 오픈 소스 Creative Commons 인가 하에 허가되었습니다.