내 문제
RROD
나의 수리
Repair was easy enough, just followed the directions. May want to watch a video or 2 on the X clips, pretty easy to destroy the whole motherboard if you screw this part up.
내 조언
The whole process was pretty easy. To do the reflow, instead of initially heating the board with the heat gun, I put it in the oven at 200 degrees for 10 min to uniformly heat the board before I started; it's not too hot to hurt anything. From there I heated each of the chips with the heat gun on high for about 4 minutes total and then let the motherboard sit for about an hour.
댓글 0개