기기를 수리하세요 커뮤니티 상점

Eufy Video Doorbell 2k (Battery-Powered) Teardown

작성자 Muzaffar (및 기여자 1명)
게시일: December 3, 2022
  • 댓글 9
  • 즐겨찾기 0
  • 조회수: 3.2k

Eufy Video Doorbell 2k (Battery-Powered) Teardown

작성자 Muzaffar (및 기여자 1명)
게시일: December 3, 2022
  • 댓글 9
  • 즐겨찾기 0
  • 조회수: 3.2k

분해도

소개

Eufy Video Doorbell 2K (Battery-Powered) a doorbell security camera that can be installed outdoors. Unfortunately for my unit, water got inside and fried a chip rendering the unit inoperable after 2 years of service. Since Eufy does not have a repair centre here in Malaysia, I decided to open it up and take a look inside.

note: Most of the images I took was is Portrait, thus images might be slightly weird or looks like it was rotated to the left.

해당 분해도는 수리 안내서가 아닙니다. Eufy Doorbell 2k (Battery-Powered) 수리는 저희 서비스 설명서를 사용하십시오.

  1. Eufy Video Doorbell 2k (Battery-Powered) Teardown, Eufy Video Doorbell 2k (Battery-Powered) Teardown: 1 단계, 이미지 1/1

    • Using Phillips 000 screw driver remove 8 screws at the back.

    편집

  2. Eufy Video Doorbell 2k (Battery-Powered) Teardown: 2 단계, 이미지 1/1

    • Using a metal or plastic prying tool, insert it in between the seems. Then carefully lift the back unit out. Once one side is open simply lift it out from the front cover.

    편집

  3. Eufy Video Doorbell 2k (Battery-Powered) Teardown: 3 단계, 이미지 1/3 Eufy Video Doorbell 2k (Battery-Powered) Teardown: 3 단계, 이미지 2/3 Eufy Video Doorbell 2k (Battery-Powered) Teardown: 3 단계, 이미지 3/3

    • Battery is connected to the main board. Using a tweezer remove the battery connector.

    편집

  5. Eufy Video Doorbell 2k (Battery-Powered) Teardown: 4 단계, 이미지 1/1

    • Water manage to get into my unit and fried this chip. Suggest you use a rain cover if this doorbell is expose to weather outdoors. There are a lot of 3D printed rain covers for this doorbell.

    편집

  6. Eufy Video Doorbell 2k (Battery-Powered) Teardown: 5 단계, 이미지 1/2 Eufy Video Doorbell 2k (Battery-Powered) Teardown: 5 단계, 이미지 2/2

    • Remove 4 screws with a Phillips 000.

    • Remove 2 screws with a Phillips 0.

    편집

  7. Eufy Video Doorbell 2k (Battery-Powered) Teardown: 6 단계, 이미지 1/1

    • Disconnect the connector.

    • Disconnect the connector.

    • CCD of the camera

    • Do not touch the CCD. If finger prints got stuck it will be difficult to clean.

    편집

  8. Eufy Video Doorbell 2k (Battery-Powered) Teardown: 7 단계, 이미지 1/2 Eufy Video Doorbell 2k (Battery-Powered) Teardown: 7 단계, 이미지 2/2

    • Battery details and specification.

    • You can use a multimeter to check the voltage of the battery. Mine was still good at 3.9V. Unfortunately the chip got fried.

    편집

작성자

다른 기여자 1명과 함께

Muzaffar

회원 가입일: 05/12/19

145 평판

안내서 1개 작성함

배지: 0

댓글 9개

Goodacternoon po Maam/Sir?

pwedi poba mag order board lang

LAMPUTE VENT - 답글

And what happends next?

kubakumate - 답글

This is great. Any suggestions for sourcing a new battery pack?

Tezza - 답글

My battery may be shot. Same as in pics. Where can I get a replacement?

Joe Guy - 답글

I tried changing the battery in mine. Got it sourced individual cell and attached to the existing points (by removing old cells). It got really hot. Seems my chip got fried as well. Not sure how to check if there is anything else faulty than BAttery Chip?

Rishi Gaurav Gupta - 답글

댓글 쓰기

조회 통계:

24 시간 전: 2

7일 전: 11

30일 전: 32

전체 시간: 3,234