Remove rear cover using little notch located at bottom of phone

Remove 1620 mAh battery

Remove SD card

Remove (6) Torx T7 screws

You may have to remove VOID sticker from one of the screws

Use opener tool to carefully pry cover off

Speaker is located inside back cover

Main Camera

Headphone jack

Vibration motor

Carefully unplug board

Carefully remove camera cover, slowly peeling off tape to reuse

Remove and unplug vibration motor

Remove (2) Phillips heads screws (one is shown, the other is on the left lower side)

Disconnect two cables from logic board to screen. Be very careful not to break our bend too badly.

Main camera connection & front camera

Using pick or pry tool, slowly remove screen from frame. Tape and adhesive is holding it on so work slowly and use heat gun if needed.

For the most part, this teardown is pretty straightforward with the headphone jack fused to main board. The display looks to be fused to the screen so replacement of either means replacement of both.