주요 콘텐츠로 건너뛰기

소개

How-To remove the internal hard drive contained within the external enclosure.

부품

지정된 부품이 없습니다.

  1. LaCie Minimus (2 TB hard drive)
    • LaCie Minimus (2 TB hard drive)

  2. Turn the drive over, noting the black rubber strips.  Carefully peel each strip off, to reveal a set of two phillips screws under each strip. Turn the drive over, noting the black rubber strips.  Carefully peel each strip off, to reveal a set of two phillips screws under each strip. Turn the drive over, noting the black rubber strips.  Carefully peel each strip off, to reveal a set of two phillips screws under each strip.
    • Turn the drive over, noting the black rubber strips. Carefully peel each strip off, to reveal a set of two phillips screws under each strip.

  3. Remove the two sets of phillips screws and set them aside. Remove the two sets of phillips screws and set them aside.
    • Remove the two sets of phillips screws and set them aside.

  4. Carefully push on the front, black faceplate to slide the drive and housing out of the case.
    • Carefully push on the front, black faceplate to slide the drive and housing out of the case.

  5. Note the label:  Warranty Void If Seal Broken.  In this case, we want to retrieve the data and do not care about the warranty.  Remove the label, to expose one of the four total screws on the side to remove the internal drive. Note the label:  Warranty Void If Seal Broken.  In this case, we want to retrieve the data and do not care about the warranty.  Remove the label, to expose one of the four total screws on the side to remove the internal drive.
    • Note the label: Warranty Void If Seal Broken. In this case, we want to retrieve the data and do not care about the warranty. Remove the label, to expose one of the four total screws on the side to remove the internal drive.

  6. Carefully remove the four screws holding the drive in the caddy, making sure that the hard drive does not slip out or damage the SATA controller card towards the rear of the case. Carefully remove the four screws holding the drive in the caddy, making sure that the hard drive does not slip out or damage the SATA controller card towards the rear of the case.
    • Carefully remove the four screws holding the drive in the caddy, making sure that the hard drive does not slip out or damage the SATA controller card towards the rear of the case.

  7. The drive is now removed.  Use an external hard drive reader, etc., such as the Cavalry in the second picture, to hopefully access your drive. The drive is now removed.  Use an external hard drive reader, etc., such as the Cavalry in the second picture, to hopefully access your drive.
    • The drive is now removed. Use an external hard drive reader, etc., such as the Cavalry in the second picture, to hopefully access your drive.

결론

To reassemble your device, follow these instructions in reverse order.

다른 3명이 해당 안내서를 완성하였습니다.

Lance Wessel

회원 가입일: 2010년 08월 31일

185 평판

안내서 1개 작성함

Thank you !

We will need it ....

Giuseppedegioia - 답글

Drive inside say

5VDC / 12VDC - 0.5A 0.7A

But my replace say:

5VDC, 0,60A

12VDC, 0,45A

Is that OK or should I not change?

hlundstedt - 답글

댓글 쓰기

조회 통계:

24 시간 전: 1

7일 전: 19

30일 전: 83

전체 시간: 4,843