해당 분해도에 사용된 도구

해당 분해도는 수리 안내서가 아닙니다. Lexmark Z11 수리는 저희 서비스 설명서를 사용하십시오.

  1. Be sure to remove the power cord and all other connections to and from the device.
    • Be sure to remove the power cord and all other connections to and from the device.

    • Remove easily detachable parts.

    댓글 쓰기

  2. To remove the cover and housing use a screw driver to remove the highlighted screws.
    • To remove the cover and housing use a screw driver to remove the highlighted screws.

    댓글 쓰기

  3. Fixmas/픽스마스 분위기를 띄우세요
    FIXMAS12 코드로 $50 이상 구매시 $12 할인을 받으십시오
    Fixmas/픽스마스 분위기를 띄우세요
    FIXMAS12 코드로 $50 이상 구매시 $12 할인을 받으십시오
    • Additionally, remove those two screws at the bottom of the device.

    댓글 쓰기

    • Press the nib marked in green inside and slightly lift the housing from the back plate shown in the first image here.

    • The housing can be removed by lifting and rotating it around the catches on the lower front side of the device highlighted in purple. Finally, it is shifted slightly to the front out of those catches.

    댓글 쓰기

    • With this inner part nearly everything is easily accessible. There are two stepper motors:

      • NMB PM42L-048-FEA8

        • 4 wires

      • Mitsumi H9601

        • 5 wires, can probably be resoldered to use 4 or 6 wires

    • There is also an electronics board as well as smaller useful parts like buttons, LEDs, light barriers.

      • Motorola XC901051FTA

      • Motorola 34063 (switching voltage regulator)

    댓글 쓰기

    • The motors in detail.

    댓글 쓰기

raumschaum

회원 가입일: 2013년 02월 27일

371 평판

안내서 3개 작성하였습니다

댓글 쓰기

조회 통계:

지난 24시간: 1

지난 7일: 3

지난 30일: 9

전체 시간: 1,026