메인 콘텐츠로 스킵하기

소개

The hair dryer is an electromechanical device that blows ambient or hot hair over damp hair to speed the evaporation of water to dry the hair. Developed during the early-1920s in Germany. After decades of development, the hair dryer becomes a daily device to dry hair and style.

해당 분해도는 수리 안내서가 아닙니다. Model CVS124A 수리는 저희 서비스 설명서를 사용하십시오.

  1. Locate the screw on the handle and remove them with a Phillips screwdriver.
    • Locate the screw on the handle and remove them with a Phillips screwdriver.

    • All of the hair dryer’s components are held together by these two screws. Parts may quickly separate after screw removal.

  2. Remove the top portion of the handle. The model information and warnings are engraved on the top portion.
    • Remove the top portion of the handle.

    • The model information and warnings are engraved on the top portion.

  3. Remove the settings switch by lifting straight up.
    • Remove the settings switch by lifting straight up.

  4. Remove the internal switch from the rear portion of the handle.
    • Remove the internal switch from the rear portion of the handle.

  5. Remove the lower portion of the handle by sliding the peg out of the slot at the top of the handle.
    • Remove the lower portion of the handle by sliding the peg out of the slot at the top of the handle.

  6. Handle - ABS injection moulding
    • Handle - ABS injection moulding

  7. Take off the protective jacket outside the wire. Take off the protective jacket outside the wire.
    • Take off the protective jacket outside the wire.

  8. Separate the iron case with the back case by using 6.5mm flathead screwdriver. Take off the fan after separation. Pull on the back of the fan motor to gently lift the motor out of the hair dryer.
    • Separate the iron case with the back case by using 6.5mm flathead screwdriver. Take off the fan after separation.

    • Pull on the back of the fan motor to gently lift the motor out of the hair dryer.

  9. The fan motor The fan motor
    • The fan motor

  10. Separate the back and front case by using the 6.5mm flathead screwdriver.
    • Separate the back and front case by using the 6.5mm flathead screwdriver.

  11. At this point you can pull the complete electronic sub assembly  from the front case. Coils
    • At this point you can pull the complete electronic sub assembly from the front case.

    • Coils

  12. All the parts after the teardown.
    • All the parts after the teardown.

任心怡

회원 가입일: 2018년 10월 15일

205 평판

안내서 1개 작성함

댓글 쓰기

조회 통계:

지난 24시간: 2

지난 7일: 5

지난 30일: 8

전체 시간: 258