주요 콘텐츠로 건너뛰기

소개

The screws could be torx or Philips head in the body and where the neck bolts to the body.

해당 분해도는 수리 안내서가 아닙니다. RedOctane X-Plorer 수리는 저희 서비스 설명서를 사용하십시오.

  1. Remove all 16 #10-torx screws from the back side of the case.
    • Remove all 16 #10-torx screws from the back side of the case.

    • Gently separate the case pieces.

    • A strong magnet helps greatly when taking out the screws.

    • Keep in mind when resembling, the case is plastic so, don't tighten the screws too tight.

  2. Unscrew the 4 #10-torx screws.
    • Unscrew the 4 #10-torx screws.

  3. Unscrew the 2 Philips head screws Peel off the pads. Push the colored keys out from the other side.
    • Unscrew the 2 Philips head screws

    • Peel off the pads.

    • Push the colored keys out from the other side.

  4. Unscrew the red screws and pull the board out. Then, unscrew the blue screws Pull the bracket things off.
    • Unscrew the red screws and pull the board out.

    • Then, unscrew the blue screws

    • Pull the bracket things off.

    • Pull out the pin.

  5. Unscrew the 4 Philips head screws.
    • Unscrew the 4 Philips head screws.

  6. Unscrew these 2 Philips head screws.
    • Unscrew these 2 Philips head screws.

  7. Push from the other side until it comes out. Take the spring off with the connector
    • Push from the other side until it comes out.

    • Take the spring off with the connector

  8. Unscrew the 4 Philips head screws. Peel off the contact pads.
    • Unscrew the 4 Philips head screws.

    • Peel off the contact pads.

thefluffyfist

회원 가입일: 2017년 04월 08일

488 평판

안내서 2개 작성하였습니다

댓글 쓰기

조회 통계:

24 시간 전: 1

7일 전: 8

30일 전: 27

전체 시간: 717