해당 분해도에 사용된 도구

소개

I've found a vacuum in my utility room. Since I almost never use it, I thought it was a good idea to see how it works... So let's go!!

해당 분해도는 수리 안내서가 아닙니다. Rowenta AC6221 수리는 저희 서비스 설명서를 사용하십시오.

  1. The 4.8 Rowenta vacuum can be used  for a variety of purposes.
    • The 4.8 Rowenta vacuum can be used for a variety of purposes.

    • It is charged through its pedestal. The power of the pedestal is:

      • Input: 230V - 50 Hz - 7W (AC)

      • Output: 7.5V - 300 mA (DC)

    댓글 쓰기

  2. This vacuum has several parts:
    • This vacuum has several parts:

      • The tip

      • The reservoir which holds the dust and debris

      • The engine (4.8V)

      • The pedestal

      • The power supply

    • From top to bottom, the reservoir contains 3 parts: the housing, container, and filter.

    댓글 쓰기

    • Remove the two outer Philips #00 screws from the bottom of the engine.

    • The back of the circuit board will now be visible.

    댓글 쓰기

    • Remove the two inner screws.

    • Insert a flat screwdriver between the cover and the base of the engine and remove the cover.

    댓글 쓰기

  3. Fixmas/픽스마스 분위기를 띄우세요
    FIXMAS12 코드로 $50 이상 구매시 $12 할인을 받으십시오
    Fixmas/픽스마스 분위기를 띄우세요
    FIXMAS12 코드로 $50 이상 구매시 $12 할인을 받으십시오
    • The wires of the vacuum are now visible.

    댓글 쓰기

    • The wires of the vacuum are now visible.

    • The wires connect the charger light, switch,engine, and power wires.

    • The green box labels the engine.

    • The orange box labels one of the four batteries (4*1.2V)

    댓글 쓰기

    • The top of the circuit board contains components including capacitors, resistors, wires, and a chip.

    • The bottom side shows the tracks that connect the components.

    댓글 쓰기

    • Remove the screw securing the handle with a screwdriver.

    • Open the handle to see the inside using the flat screwdriver.

      • Warning: The handle is difficult to open

      • Warning: In this procedure, the handle was not opened to keep the vacuum intact.

    댓글 쓰기

    • This is the pedestal that will be torn down.

    댓글 쓰기

    • At the bottom of the pedestal, remove the 4 rubber pieces.

      • Note: This step provides access to 4 Philips screws.

    • Remove screws using a screwdriver.

    댓글 쓰기

    • Lift the plastic piece carefully from the bottom of the pedestal.

    댓글 쓰기

    • Inside the pedestal, the power cable separates into 2 wires. Each wire is connected to a conductive piece.

    • This completes the vacum cleaner teardown

    댓글 쓰기

Bob

회원 가입일: 2010년 04월 17일

708 평판

안내서 3개 작성하였습니다

This could use some discussion of how to replace the rechargeable batteries used in portable vacuum cleaners.

Wayne Seltzer - 답글

댓글 쓰기

조회 통계:

지난 24시간: 5

지난 7일: 10

지난 30일: 36

전체 시간: 5,780