주요 콘텐츠로 건너뛰기

필요한 것

해당 분해도는 수리 안내서가 아닙니다. Suzuki FA50 Moped 수리는 저희 서비스 설명서를 사용하십시오.

  1. Suzuki FA50 Moped Throttle Cable Teardown, Suzuki FA50 Moped Throttle Cable Teardown: 1 단계, 이미지 1/1
    • Here is the assembled throttle cable. It seems to be assembled correctly, but certainly does not function properly.

  2. Suzuki FA50 Moped Throttle Cable Teardown: 2 단계, 이미지 1/2 Suzuki FA50 Moped Throttle Cable Teardown: 2 단계, 이미지 2/2
    • The throttle parts.

    • The only logical way for me to assemble these parts were:

    • Insert needle into gold-colored cylinder.

    • Insert retaining clip on top of needle.

    • Then compress and insert the spring (see following steps on how the spring was inserted).

  3. Suzuki FA50 Moped Throttle Cable Teardown: 3 단계, 이미지 1/1
    • The throttle cable without any parts.

    • The round, gray top screws into the carburetor.

  4. Suzuki FA50 Moped Throttle Cable Teardown: 4 단계, 이미지 1/1
    • To assemble the throttle cable:

    • I first use a pair of needle-nose pliers to compress the spring as much as I can.

    • This allows me to insert the throttle cable into the gold-colored cylinder without having to meddle with the spring too much.

  5. Suzuki FA50 Moped Throttle Cable Teardown: 5 단계, 이미지 1/2 Suzuki FA50 Moped Throttle Cable Teardown: 5 단계, 이미지 2/2
    • I attach the throttle cable to the bottom of the gold cylinder and then route it through the cylinder's side slot.

    • The alternate view (picture 2) shows how everything looks internally.

    • After the throttle cable is in place, I let go of the spring into the cylinder.

  6. Suzuki FA50 Moped Throttle Cable Teardown: 6 단계, 이미지 1/2 Suzuki FA50 Moped Throttle Cable Teardown: 6 단계, 이미지 2/2
    • I'm simulating screwing on the throttle to the carburetor by compressing the gold cylinder against the gray cap. As you can see, the spring compresses, and the throttle cable pops outward.

    • When I twist the moped's throttle, the throttle cable goes inwards. I believe this is the desired action for the cable.

    • There are two problems, however:

    • Nothing pushes the throttle cable back out when I release the moped's throttle.

    • The throttle needle does not move, but to my understanding it should go upward when I apply the throttle.

    • Please check out my Answers question if you can help me solve this problem! Thanks a lot!

Miroslav Djuric

158,466 평판

안내서 144개 작성하였습니다

댓글 2개

which way does you set the throttle when you put it in

ladell - 답글

It appears to be correctly assembled however the cable isn't bottomed out on the cup to allow for free movement, I think you may have put a flat spot in to the cable itself that's not allowing the cup to bottom out on it and giving you the return movement.

Ken James - 답글

댓글 쓰기

조회 통계:

24 시간 전: 1

7일 전: 18

30일 전: 41

전체 시간: 12,964