메인 콘텐츠로 스킵하기
도움말
10단계 편집 중 —

단계 유형:

끌어서 재배열 합니다

Using a brass punch, slowly knock out the main housing spring pin.

Make sure the hammer is forward and not pulled back! The spring in the main housing provided pressure for the hammer. Your punch will be difficult to remove and the main housing can fly off when you pull the punch out if the hammer is pulled back.

Remove the main housing to reveil the Sear/Trigger/Grip Safety spring (This is a flat leaf spring so no worries about parts flying everywhere). It will just fall out or shake it out (tweezers not needed, just used to show spring placment).

귀하의 기여는 오픈 소스 Creative Commons 인가 하에 허가되었습니다.