주요 콘텐츠로 건너뛰기

해당 분해도에 사용된 도구

해당 분해도는 수리 안내서가 아닙니다. turbidity 수리는 저희 서비스 설명서를 사용하십시오.

  1. first thing  u want to do is take out the two screws on each side of the meter and also take out  all the screws on the bottom  you will need a philips head  screw driver first thing  u want to do is take out the two screws on each side of the meter and also take out  all the screws on the bottom  you will need a philips head  screw driver first thing  u want to do is take out the two screws on each side of the meter and also take out  all the screws on the bottom  you will need a philips head  screw driver
    • first thing u want to do is take out the two screws on each side of the meter and also take out all the screws on the bottom you will need a philips head screw driver

  2. Now unscrew the 4 screws on the face plate  and  you will be able to lift the cover  off  the meter  but be carful as there are a few plugs and screws  left  for you to remove Now unscrew the 4 screws on the face plate  and  you will be able to lift the cover  off  the meter  but be carful as there are a few plugs and screws  left  for you to remove
    • Now unscrew the 4 screws on the face plate and you will be able to lift the cover off the meter but be carful as there are a few plugs and screws left for you to remove

  3. iPhone X Fix Kits

    Warranty up? No worries, we’ve got the fix.

    지금 장보기

    iPhone X Fix Kits

    Warranty up? No worries, we’ve got the fix.

    지금 장보기
  4. Unplug the three prong  plug  and unscrew and pull out all the wires off the terminal block now  you are able to take the cover completely off> the terminal block is  basically a  neat  way of  distributing power NOTE: mark where each wire goes on the terminal block for easy re installation
    • Unplug the three prong plug and unscrew and pull out all the wires off the terminal block now you are able to take the cover completely off> the terminal block is basically a neat way of distributing power

    • NOTE: mark where each wire goes on the terminal block for easy re installation

  5. Unscrew  all the nuts shown using an adjustable wrench to remove  circuit board Unscrew  all the nuts shown using an adjustable wrench to remove  circuit board
    • Unscrew all the nuts shown using an adjustable wrench to remove circuit board

  6. tilt the bulb so screw access is available  as shown then slide bulb  canister  off telescopic shaft tilt the bulb so screw access is available  as shown then slide bulb  canister  off telescopic shaft
    • tilt the bulb so screw access is available as shown then slide bulb canister off telescopic shaft

  7. tools used :                                                                                 philips head screwdriver                                            flat head screwdriver                                                                                     adjustable wrench
    • tools used : philips head screwdriver flat head screwdriver adjustable wrench

maxwell

회원 가입일: 2018년 04월 19일

142 평판

안내서 1개 작성함

댓글 쓰기

조회 통계:

지난 24시간: 0

지난 7일: 0

지난 30일: 1

전체 시간: 130