To anyone who finds this years later that has an older Breville BOV800XL/A: Besides having a few switches that were bad on my board, I also had a couple of rotary knobs that weren’t working consistently and one of them failed after I made the switch repair (likely from pulling the knobs off from disassembly). I ordered replacement control boards from 2 places online but I kept getting sent the updated board that has a 10-pin connector and different knobs. After a lot of digging I think I found the part on Mouser that seems to be a direct replacement. I couldn't figure out the specs of the original encoders but these are dimensionally accurate and seem to be working fine after soldering them in and testing for a while. https://www.mouser.com/ProductDetail/Bou...-P19-N0010?qs=IS%252B4QmGtzzphZQR7x0B%252BlA%... Part information just in case the link is ever down Bourns 23mm Low Profile Increment-Ring Encoder Mfr. part number: PER231-P19-N0010