귀하의 기기에 대한 안내서, 부품 및 답변에 신속히 접근할 수 있습니다
장바구니가 비어 있는 것 같습니다
I fitted an SSD to replace the HDD. The HDD had a thermal sensor cable attached and there was no place to connect this to the SSD.
As a result, the fan ran fast. I downloaded some free software, ‘SSD Fan Control’, which did a great job in taming the fan speed. The surplus thermal sensor cable I just taped neatly to the SSD to stop it from moving around.
I followed the above tips and used chop sticks as struts to support the internal screen at an angle, whilst I worked on the hard drive. Allowed me to skip the remaining cable removal steps and go straight to step 10. And I didn’t need an extra set of hands to hold the screen whilst I worked.
This ribbon had me flumoxed for a while. I had expected to have to remove the terminal from the circuit board. All you need to do it gently pull on the ribbon directly and it will come out of the terminal.
Agree with the other comments here. Despite buying suction cups, not sure they were necessary as the screen removed very easily. A sat nav suction cup would do the job fine.
존 매든 배지 획득
@ 12시 36분 33초
댓글 "iMac Intel 27" EMC 2309 and 2374 Hard Drive Replacement"를/을 작성하였습니다.
@ 01시 25분 37초
댓글 "iMac Intel 27" EMC 2309 and 2374 Display Replacement"를/을 작성하였습니다.
@ 01시 23분 20초
@ 01시 22분 06초
댓글 "iMac Intel 27" EMC 2309 and 2374 Glass Panel Replacement"를/을 작성하였습니다.
@ 01시 20분 51초
iMac Intel 27" EMC 2309 and 2374 Hard Drive Replacement를/을 좋아요 하였습니다.
@ 03시 48분 54초
일단 획득하면, 귀하께서는 그들의 시간당 평판 획득 도표를 볼 수 있습니다.
도표가 어떻게 보여질지에 대한 미리보기입니다:
아직 획득한 평판이 없습니다.