주요 콘텐츠로 건너뛰기

Second generation of Wi-Fi iPad, released on March 11, 2011. Model number A1395. Repair is difficult and will require heat.

250 질문 전체 보기

Ipad 2 not charging after digitizer replacement. Any ideas?

I've just replaced the front panel and digitiser on an iPad 2 Wifi. I've been using it for a few hours and battery life has depleted at its usual rate. When plugging it into the mains or laptop it doesn't show as charging or hold any charge.

I've tried turning off and resetting but have been unsuccessful.

Has anyone else had a similar problem or is able to give me any advice?

I'll be opening her up again tomorrow to have a closer inspection.

답변되었습니다! 답변 보기 저도 같은 문제를 겪고 있습니다

좋은 질문 입니까?

점수 1
댓글 1개

Many thanks for the replies.

It was indeed a damaged charging dock connector. Fortunately it was a £3.99 fix.

Thanks again

댓글 달기

답변 4개

선택된 답변

Hi

As mentioned above if you are using a metal spudger to get the old screen off, you may have gone through the charging dock cable, however before removing this new digitizer, please ensure you try another charger in case the current one is faulty

Regards

Ali

해당 답변은 도움이 되었습니까?

점수 0
댓글 달기
가장 유용한 답변

see if you disconnected charging port cable or damaged it by any chance

해당 답변은 도움이 되었습니까?

점수 1
댓글 달기

cheak the power cable if there is any small crack , when you open the digitizer maybe you dameg it it is located near the volume switch

해당 답변은 도움이 되었습니까?

점수 0
댓글 달기

hiya i wonderd if you can help me i have took the digitilzer off a ipad 2 wifi and the plastic bits where the digilizer cable goes in has come off n how do i put them bk on or does it affect it without them please can you email me on fozzy58@outlook.com

해당 답변은 도움이 되었습니까?

점수 0
댓글 달기

귀하의 답변을 추가하세요

Robo 님은 대단히 고마워 할 것입니다.
조회 통계:

24 시간 전: 1

7일 전: 2

30일 전: 8

전체 시간: 3,305