주요 콘텐츠로 건너뛰기

기기를 수리하세요

수리할 권리

상점

처리 속도가 빨라진 iPhone 3G 개선 버전. 이 기기의 수리는 3G와 유사하며 간단한 스크루드라이버, 비집는 도구가 필요합니다. 모델 A1303 / 16GB 또는 32GB 용량 / 검정 또는 흰색 플라스틱 뒷면.

1970 질문 전체 보기

home button not working after front display instal

I recently bought just the back side of an iphone 3gs for AT&T (not sure if that matters) and I bought a full iphone 3 gs front assembly kit (not through Ifixit) and after installation the touch screen works, the picture comes in crystal clear, but my home button isn't working, help!!

이 질문에 답하세요 저도 같은 문제를 겪고 있습니다

좋은 질문 입니까?

점수 0
의견 추가하세요

답변 1개

The home button is installed in the mid frame assembly that holds the LCD and Digitizer. The home button has two small pins that sit on top of the Dock connector when the screen is installed which is how the home button makes contact and works.

If the pins are bent or broken....you would need to pop the lcd out, heat and pry the glass off the frame and then replace the home button. If the pins are in good order....you can test to see if its a Dock issue but opening the screen up, but leaving it plugged in. While the phone is on...use a small screwdriver to touch one of the metal pads on top of the dock where the home button pins make contact....and touch the shaft of the screwdriver to the metal (chrome color) rim around the back housing. If it makes the home button actuate on the phone...then the issue is with the button itself and you should just replace the button. If it wont even actuate the home button activity on the phone from the dock....then the dock is bad and needs replaced. You can try cleaning those contacts and pins first, but normally it just needs replaced.

Hope this helps

해당 답변은 도움이 되었습니까?

점수 0
의견 추가하세요

귀하의 답변을 추가하십시오

[deleted] 가/이 대단히 고마워 할 것입니다.
조회 통계:

24 시간 전: 0

7일 전: 0

30일 전: 0

전체 시간: 110