기기를 수리하세요 커뮤니티 상점

2012년 9월 12일에 발표된 여섯 번째 Apple iPhone입니다. 수리는 이전 모델과 유사하며 스크류 드라이버 및 비집는 도구가 필요합니다. GSM 또는 CDMA / 16, 32, 또는 64GB / 검정색 또는 흰색으로 제공하였습니다.

2522 질문 전체 보기

옵션

I got the nand error, what precautions should I be taking?

Hello,

I was recently replacing a customers screen when I was faced with the nand error! After much frustration I did some research and disconnected the 3rd flex cable for the proximty sensor and front facing camera. By doing this, the phone successfully booted up. Sequentially I ordered a replacement flex cable, however Im wondering what precautions I should be taking when installing the flex. I usually transfer this flex cable over very carefully from the old screen to the new one, so this error was a surprise to me.

I also noticed that the screen replacement I received has an extremely loose front facing camera bezel, could this have caused and error?

Theres also a black rubber square like (bezel maybe) that comes out from under the flex, where should that be placed?

이 질문에 답하기 저도 같은 문제를 겪고 있습니다

좋은 질문 입니까?

예 아니요
점수 -1
댓글 1개

UPDATE:

Just got the replacement part in for the proximity sensor and front facing camera, installation went well and phone booted up properly

의

댓글 달기

답변 3개

필터:
가장 유용함 가장 최근 가장 오래된
가장 유용한 답변

옵션

Seen this before you damaged the ribbon cable removing it - it is very fragile and you most likely caused the damage when removing it from the old screen. You need to heat it to soften the glue and not just pull at it to remove it. Same with the home button - heat up the flex to soften the glue beforehand.

Also most replacement screens dont come with the front camera bezel plastic and it shouldn't be loose - you usually transfer it from the old one and glue it in place on the new one.

해당 답변은 도움이 되었습니까?

예 아니요
점수 2
댓글 달기

옵션

Hi there I have never came across this error but you must have damaged it in someway maybe you tilted the screen to high when taking the emi sheild off and damaged it hard to say

해당 답변은 도움이 되었습니까?

예 아니요
점수 0

댓글 2개:

No the camera bezal loose would not affect this and the little black peice are you referring to the spacer that is used and has a hole init?

의

Yea thats what Im referring to

의

댓글 달기

옵션

That spacer is just a spacer. Do not screw the long screw in so tight that the retaining plate bends, and then everything should function fine without it.

해당 답변은 도움이 되었습니까?

예 아니요
점수 0
댓글 달기

귀하의 답변을 추가하세요

iMatt 님은 대단히 고마워 할 것입니다.
조회 통계:

24 시간 전: 0

7일 전: 0

30일 전: 0

전체 시간: 190