주요 콘텐츠로 건너뛰기

기기를 수리하세요

수리할 권리

상점

4세대 iPhone. 수리는 간단하지만 앞면 유리와 LCD를 하나의 유닛으로 교체해야 합니다. GSM / 8, 16 또는 32GB 용량 / Model A1332 / 검정 또는 흰색.

3294 질문 전체 보기

iPhone unable to charge (After Replacement of Speaker and Home Button)

I've just replaced the home button and the speaker enclosure for my iPhone and reassembled it all back.

After the repair, the iPhone is unable to turn on. The battery seemed flat so I tried to charge it and it'll display the "exhausted battery" icon, proceed to the apple logo, and turn itself back off after several seconds.

I've replugged it in again and left it on charge for another 15 mins but still get the same results each time I repeat the process

Any ideas of which affected components may have contributed to this issue? (possibly a misconfiguration (mismatched screws?) or was any of the components damaged during repair?)

(I've tried a power cycle, no results and I've tried reassembling the whole thing again, still same issue)

이 질문에 답하세요 저도 같은 문제를 겪고 있습니다

좋은 질문 입니까?

점수 0

댓글:

SOLVED: Replaced the battery and the iPhone works perfectly fine afterwards.

의견 추가하세요

플러그없이 공부하세요

Mac 배터리 수리 키트

수리 키트 쇼핑하기

플러그없이 공부하세요

Mac 배터리 수리 키트

수리 키트 쇼핑하기

답변 1개

가장 유용한 답변

Make sure you have the dock connector plug seeded correctly inside.

If it is then it's possible you have damaged it during disassembly

해당 답변은 도움이 되었습니까?

점수 1

댓글:

I don't think I detached the actual dock connector from where it originally was, but I do remember attaching/detaching the plug from the motherboard. Though, I can't quiet tell whether the plug has been seeded correctly into each prongs or not (they're very small and completely covered once plugged in).

But as far as I can tell, I made sure the plug clicked and aligned properly into the allocated prongs during each assembly

If your sure the connector is plugged in then I would try a replacement dock as you have probobly damaged it

의견 추가하세요

귀하의 답변을 추가하십시오

Dian Octaviani 가/이 대단히 고마워 할 것입니다.
조회 통계:

24 시간 전: 0

7일 전: 0

30일 전: 0

전체 시간: 96