메인 콘텐츠로 스킵하기

2012년 9월 12일에 발표된 여섯 번째 Apple iPhone입니다. 수리는 이전 모델과 유사하며 스크류 드라이버 및 비집는 도구가 필요합니다. GSM 또는 CDMA / 16, 32, 또는 64GB / 검정색 또는 흰색으로 제공하였습니다.

3347 질문 전체 보기

Home button iPhone 5 needs hard press after replacement

So I was trying to replace my rear camera and ended up screwing the home button. I bought another and after replacing it it works for a day and then I have to press really hard for it to register a click. I open it lift up the two golden prongs that stick up and it works again for a day or so going back to hard presses. Is there a part I can replace or a fix anyone found for those pesky prongs? Which I think are my problem.

해당 질문 답변하기 저도 같은 문제를 겪고 있습니다

좋은 질문 입니까?

점수 0
의견 추가하세요

1개의 답변

가장 유용한 답변

Do you have your original button? Compare the two. I've had several replacement buttons for the Iphone 5 which have been to large, causing issues when I screw the metal plate down all the way. A quick solution is, before putting the phone back together, screw a little bit with the metal plating over the button. Loosen it / tighten it until it feels normal again. In your case it sounds like the plate is to loose, requiring you to press down hard for the button to get contact with the metal plate.

Fixed the problem for me anyways, hope it works for you as well. If the button is much larger/smaller than the original I'd suggest returning it.

해당 답변은 도움이 되었습니까?

점수 1

댓글:

Thanks for the quick answer Alex. I bought it off of ebay for cheap but it looked exactly like the old one. I'll open it again and compare them. And try to tighten the plate. One of these steps I'll crack that screen, watch me. ANd I just want the iphone 6 already!!! :)

의 답변

Yeah same results. I opened it tightened the plate. Worked like a charm for about 20 min and now I'm back to slightly harder presses. Ack, I might have to buy the whole lighting connector assembly to fix those !@#$ golden prongs.

의 답변

의견 추가하세요

귀하의 답변을 추가하십시오

eyenvent 가/이 대단히 고마워 할 것입니다.
조회 통계:

지난 24시간: 0

지난 7일: 0

지난 30일: 2

전체 시간: 1,657