기기를 수리하세요 커뮤니티 상점

Model A1224 / Mid 2007 및 Early 2008 / 2, 2.4, 또는 2.66 GHz Core 2 Duo 프로세서

548 질문 전체 보기

옵션

No Video on LCD

Hello, I have a A1224/EMC 2133 Core2 Duo 20" iMac that will not produce video on the LCD. I bought this system with a known no video issue with the intent to fix it. I am a computer repair tech with over 15 years of experience, just looking for some second opinions on how to proceed. When I originally purchased the system it would not produce video at all on LCD or external monitor, but the chime could be heard. I replaced the video card with a used x2600 card from eBay. the original card was a 2400XT. Now it outputs external video but no video on LCD. Below are the troubleshooting steps I have performed so far.

-System will produce video to an external monitor and boot to a setup disk

-Resetting PRAM had no effect

-There is no video on LCD at all. Using a flashlight, there is no ghosted image to indicate there is simply a backlight failure

-The backlight does not appear to be turning on

- Diagnostics LEDs 1,2 and 3 light up right away and stay lit up. LED 4 never comes on.

- Voltages on the power harness going into the LCD inverter are Pin1:3.3v, Pin2:0v, Pin3:-.03v, Pin4:12v. I may have the pins listed in the reverse order.

답변되었습니다! 답변 보기 저도 같은 문제를 겪고 있습니다

좋은 질문 입니까?

예 아니요
점수 1
댓글 달기

답변 2개

필터:
가장 유용함 가장 최근 가장 오래된
선택된 답변

옵션

After replacing the LVDS cable the screen comes on with backlight.

해당 답변은 도움이 되었습니까?

예 아니요
점수 0
댓글 달기
가장 유용한 답변

옵션

See if it's the inverter: iMac Intel 20" EMC 2133 and 2210 Inverter Replacement

해당 답변은 도움이 되었습니까?

예 아니요
점수 1

댓글 4개:

Would a faulty inverter cause an image to not be displayed on the LCD? Since the inverter only powers the CCFLs I would expect to still get an image on the LCD that could be seen with a flashlight.

의

Can you see a faint desktop. If so replace the inverter.

의

No, I see no image in the LCD. I also tried with a flashlight up to the screen, and no image is on the LCD at all.

의

Since I'm not getting any image on the LCD panel I decided to order an LVDS cable first. I figure my steps in order of importance are get an image on the LCD, then look into the backlight not lighting up.

의

댓글 달기

귀하의 답변을 추가하세요

Joe 님은 대단히 고마워 할 것입니다.
조회 통계:

24 시간 전: 0

7일 전: 0

30일 전: 1

전체 시간: 365