주요 콘텐츠로 건너뛰기

2012년 9월 12일에 발표된 여섯 번째 Apple iPhone입니다. 수리는 이전 모델과 유사하며 스크류 드라이버 및 비집는 도구가 필요합니다. GSM 또는 CDMA / 16, 32, 또는 64GB / 검정색 또는 흰색으로 제공하였습니다.

2522 질문 전체 보기

No signal after power flex replacement

I make this topic so other with the same problem, can find the solution here.

iPhone 5 not searching for network. Only says No service.

I had this problem when i changed powerflex on iphone 5. The screwdriver slipped and it then wouldnt find signal.

I found out this was missing:

Block Image

After soldering this it had fine signal again.

이 질문에 답하기 저도 같은 문제를 겪고 있습니다

좋은 질문 입니까?

점수 1
댓글 달기

답변 8개

가장 유용한 답변

ive located the component, its a 70-OHM-300MA resister. it is part of the phones RF TRANSCEIVER DECOUPLING.

Block Image

해당 답변은 도움이 되었습니까?

점수 1
댓글 달기

Hi after seeing your post i try to identify if my problem is the same .

Can you explain if there is a components at the place you solder ? Mine looks like none. But before solder i just want to make sure.

So you make a bridge between the two solder point ?

thanks

해당 답변은 도움이 되었습니까?

점수 0
댓글 달기

The one i fixed had broke the resistor clean off, so i just soldered between the 2 points. Try to get a magnifier to see closely if it is missing.

해당 답변은 도움이 되었습니까?

점수 0
댓글 달기

Hi thanks for your answer. I take a magnifier and see a gap between two pin next to the screw hole.

is this correct or is this the resistor behind this two pin ?

I will try to take a photo but it's not easy...

Thanks a lot..

해당 답변은 도움이 되었습니까?

점수 0
댓글 달기

Block Image

To illustrate see the image. This is the 1 or the 2 ?

Thanks

해당 답변은 도움이 되었습니까?

점수 0
댓글 달기

It is the one closest to the screw hole. So it is number 1.

해당 답변은 도움이 되었습니까?

점수 0
댓글 달기

I try but it's very difficult to sold...

해당 답변은 도움이 되었습니까?

점수 0
댓글 달기

Did but nothing change... Thanks again for your advice. I appreciate. Hope your solution work for another.

Have a good day /night

해당 답변은 도움이 되었습니까?

점수 0
댓글 달기

귀하의 답변을 추가하세요

DKHardWareGuy 님은 대단히 고마워 할 것입니다.
조회 통계:

24 시간 전: 0

7일 전: 0

30일 전: 0

전체 시간: 210