주요 콘텐츠로 건너뛰기

Apple's 2012 first-generation 7.9-inch iPad mini, with 16, 32, or 64 GB of storage and an A5 processor.

779 질문 전체 보기

Another backlight problem after changing digitizer

I have ended up with no backlight after changing my digitizer on my iPad mini A1489. I read that many say it can be fix by soldering the fuse, but my iPads circuitry seems a bit different from all of the other posts on the subject. Can anyone point me to the fuse that needs to be soldered? Does anyone offer a service so repair this correctly for me? Any help is greatly appreciated!

이 질문에 답하세요 저도 같은 문제를 겪고 있습니다

좋은 질문 입니까?

점수 0
의견 추가하세요

답변 2개

가장 유용한 답변

dont ever understand how people do this.

ALWAYS turn off and disconnect power when doing repairs.

You most likely burnt out the backlight filter

해당 답변은 도움이 되었습니까?

점수 1

댓글:

I did disconnect the battery before disconnecting anything else. That's why this is so frustrating for me. I've been fixing iPads/iPhones for years...

의견 추가하세요

Hard reset your iPad mini by pressing power and home button for 7 seconds. Supposed lost backlight comes back. If it didn't help, then we will find a solution for you ahead.

Update

Take a multimeter and check out if any of these chips are inactive. Black needle of the multimeter must be at ground. This should help you replace the bad one.

Block Image

Or watch this video and follow carefully. One mistake will damage the entire board and make it useless. https://www.youtube.com/watch?v=8je_i_za...

해당 답변은 도움이 되었습니까?

점수 0

댓글:

I have tried the hard reset several times. I also tried leaving the battery unhooked for more than 120 seconds. Still no luck.

My iPad logic board does not look the same as that one, how can I upload a picture to show you what I'm working with?

의견 추가하세요

귀하의 답변을 추가하십시오

dodgeboybrown 가/이 대단히 고마워 할 것입니다.
조회 통계:

24 시간 전: 0

7일 전: 0

30일 전: 0

전체 시간: 173