해결됨: iPhone 5 Screen Going black after replacement when put in frame - iPhone 5

iPhone 5 Screen Going black after replacement when put in frame

After repairing a customers iphone 5 and verifying the new screen functioned properly I put it back into the frame and it immediately goes black when I out the top right corner of the screen in place. If I leave just that corner slightly out it works fine. I dont know what could posibly be wrong. I thought it was the ambient light sensor thinking it was next to a face causing it to go black but I cannot confirm and dont see how just that corner would be affecting it that way,

게시일: 2015년 8월 21일

옵션

Hi Roderick,

To me, it sounds like the backlight is getting shorted out on the frame, or a screw or shield. Pull the LCD assembly back off, and inspect the cables. On the longer cable, there will be 3 solder points and a small cable that attaches to the backlight. If these solder points are exposed they can ground out on another part of the phone and cause the screen to go black. Try covering them up with some sort tape and then re-install the screen. Hope this helps!

해당 답변은 도움이 되었습니까?

예 아니요

점수 0

댓글 1개:

I appreciate it! Put a piece of tape over it and it worked perfectly

Roderick 의 2015년 8월 21일

댓글 달기

iPhone 5

iPhone 5 Screen Going black after replacement when put in frame

답변 1개