메인 콘텐츠로 스킵하기

Canon's Rebel XT is one of Canon's early entry-level DSLR's. Also marketed as the EOS 350D and the EOS Kiss Digital N.

27 질문 전체 보기

How complicated is it to replace the PASM dial using a junker?

I have a great old Rebel XT and the PASM dial has the insert missing. I have a junker camera with a perfect PASM dial. No way to just remove the PASM dial insert that I can see.

How complicated would it be just to take both cameras apart and rob the good PASM dial from the junk camera to make the good one have a legible PASM dial?

Thanks.

답변되었습니다! View the answer 저도 같은 문제를 겪고 있습니다

좋은 질문 입니까?

점수 0
의견 추가하세요

아이폰 배터리 수리 키트

Only $29.99

Buy Now

아이폰 배터리 수리 키트

Only $29.99

Buy Now

1개의 답변

선택된 해법

The insert of the mode dial is glued in. If it managed to detach itself from your good camera, it should not be too hard to get it off your junker.

There's a small positioning notch opposite the green AUTO icon, with an x-acto knife and some patience it should be possible to get the insert off.

If you opt for the disassembly route, your best bet would be to swap out the complete top covers between the two cameras. You may use the disassembly guides of the Xti/400D, there's not much difference between the two.

해당 답변은 도움이 되었습니까?

점수 1

댓글:

@kaykay This was the best guy on cameras the site has seen but we haven't seen him for a while

의 답변

의견 추가하세요

귀하의 답변을 추가하십시오

Van Adams 가/이 대단히 고마워 할 것입니다.
조회 통계:

지난 24시간: 0

지난 7일: 0

지난 30일: 0

전체 시간: 71