Nintendo handheld device released February 2011, identified by model number CTR-001.

330 질문 전체 보기

Button sticker on the motherboard replacement

Hello

I would like to know how it's possible to replace the button stickers on the motherboard for the ABXY buttons. They seem to be sticked to the board.

My Y button doesn't work well because of this

Here's a picture of what I am talking about:

https://d3nevzfk7ii3be.cloudfront.net/ig...

Thanks

Update (05/07/2016)

Hello

Thanks for your answer. I replaced the sticker between the rubber piece and the board, this sticker contained the metal pads. I put the new ones I bought on AliExpress using tweezers, in less than 30 seconds it was perfectly aligned and works fantastic.

However I teared the camera flex cable a bit and now the back camera doesn't work, it stays on black, doesn't freeze the console.

I guess due to a health problem I have for some time my head isn't where it has to be since it's the first time I tear a flex cable

Replacing the cameras is a bit more difficult, althought for me the most difficult part would be being able to put the screen back without any dust particle inside. Which has been always a pain for me..

답변되었습니다! View the answer 저도 같은 문제를 겪고 있습니다

좋은 질문 입니까?

점수 1

댓글:

I agree that putting screens on without any dust in the way is near impossible. Just keep a can of compressed air handy and do your best to keep it dust/lint free for sure. That's all I can do when replacing screens, digitizers and such.

I also didn't realize you could by the membrane button setup. That's great to know for the future. I went to the site you referenced and sure enough, there they are.

Thanks for the info and follow up!

의 답변

의견 추가하세요

US$100 이상 또는 Pro Tech Toolkit을 포함한 모든 주문의 배송은 무료입니다!

상점 둘러보기

1개의 답변

선택된 해법

If you're talking about the rubber piece between the main board and buttons, yes, it should peel right off the board without any issue. If you're saying it's stuck to the board, then you'll need a replacement piece and clean off any stuck pieces with rubbing alcohol.

If you're describing the metal "buttons" attached to the board, then that's a far more advanced repair than I believe most are able to make in this position. If this is what you're talking about, you're probably better off buying a replacement board off eBay or other site.

해당 답변은 도움이 되었습니까?

점수 0
의견 추가하세요

귀하의 답변을 추가하십시오

Alberto 가/이 대단히 고마워 할 것입니다.
조회 통계:

지난 24시간: 0

지난 7일: 1

지난 30일: 7

전체 시간: 291