주요 콘텐츠로 건너뛰기

2012년 9월 12일에 발표된 여섯 번째 Apple iPhone입니다. 수리는 이전 모델과 유사하며 스크류 드라이버 및 비집는 도구가 필요합니다. GSM 또는 CDMA / 16, 32, 또는 64GB / 검정색 또는 흰색으로 제공하였습니다.

2522 질문 전체 보기

I replace the display of iPhone5 but the touch not function correct

I changed the display of my iPhone5 following all the instructions of the guide , at the end of the iPhone is turned on and seemed to work well , the touch response was good , then during use and opening the app I've seen that sometimes the touch it is as if it were not calibrated . It happens that the screen stops for a few seconds does not activate the touch but then at the end you unlock and it works all right . I also went to a service center that made me a diagnostic and saw that the display had been mounted properly and probably the Case Study was due to defective display. Can this happen ?

이 질문에 답하기 저도 같은 문제를 겪고 있습니다

좋은 질문 입니까?

점수 0
댓글 달기

답변 1개

Is it doing this while it is NOT plugged in and charging?

If you're plugged in and charging your touch can be jumpy.

If not, you sure you seated the ribbons correctly?

해당 답변은 도움이 되었습니까?

점수 0

댓글 3개:

The dislpay respond to touch normally when you try to unlock it and entering the pin does not present problems. Navigating in the main screen is correct, the problem occurs when you go to open applications, from that moment the touch response becomes wrong and sometimes freezes. I tried to re-enter the flat but the situation is identical, also the screen is bright and without lines, the proximity sensor function properly, calls will not give problems.

I am increasingly convinced that the display may be defective

maybe the lcd screen replacement is faulty?

If the display works fine until you enter an app, sounds like an iOS issue.

Hold the power button until you see the 'Slide to Power Off' slider

DONT TOUCH IT

Instead, hold your home button until your screen flashes back to the springboard.

Then reboot your iPhone.

댓글 달기

귀하의 답변을 추가하세요

Daniele Di Tullio 님은 대단히 고마워 할 것입니다.
조회 통계:

24 시간 전: 0

7일 전: 2

30일 전: 2

전체 시간: 82