주요 콘텐츠로 건너뛰기

Repair guides and support for motorcycles manufactured by the German motor group, BMW.

18 질문 전체 보기

Why wont 1985 bmw k100 stay running

have 1985 bmw k100. turn key, hear fuel pump. press starter, bike starts right up, then sputters and dies. then hear fuel pump again, will start right up again, sputter and die. when engine starts, i dont hear fuel pump. I have changed the ECU and the fuel pump relay.

이 질문에 답하기 저도 같은 문제를 겪고 있습니다

좋은 질문 입니까?

점수 0
댓글 달기

답변 2개

가장 유용한 답변

Too many causes to provide an "answer". On the K's the pump is wired off the level sensor.

I'd lift the pump out, disconnect both + & - wires (put hose over ends=no sparks) and directly put wires on the pump, - to ground & hold the + to the battery just as you start the engine.

This will parse a mechanical vs electrical problem.

If it runs ok, it's electrical: get the Clymer manual (M500) to trace power wiring.

If it still sputters & dies, I'd put pressure gauge inline of pump to injector rail. It should be ~38psi.

The regulator may be bad (pinch the hose of rail to regulator to see), but more likely the pump can't keep up.

I've build 3 K bikes from wrecks and worked on many others.

해당 답변은 도움이 되었습니까?

점수 1
댓글 달기

Yes—This could be caused by many things. —- Also consider faulty Hall Effect Sensor, which is used as a crankshaft position sensor. Their failure is not uncommon in older K100s.

해당 답변은 도움이 되었습니까?

점수 0
댓글 달기

귀하의 답변을 추가하세요

bryan christensen 님은 대단히 고마워 할 것입니다.
조회 통계:

24 시간 전: 0

7일 전: 8

30일 전: 30

전체 시간: 1,519